Danley DNA 10K4, Руководство пользователя

Страница: 32 / 49

32
IP Mode
The Ethernet IP address may be automatic “ Auto ” or may be a fixed static value “ Static ” as
determined by the “IP Mode” page of the “ UTILITY ” menu.
WARNING – Do NOT use Static mode unless your IT system specifically requires it. Auto mode
should always be used where possible since in this mode, the Device can always be ‘discovered’ by
the PodWare application. When in Static mode, the IP Address will flash on the Home screen.
Also see Ethernet Configurations .
IP Static
This allows the Static Ethernet IP address to be adjusted by the three rotary encoders on the IP Static
page of the “
UTILITY ” menu. This will only have effect when in Static mode.
Store Snapshot
This page of the “ UTILITY ” menu allows a Snapshot of the device to be stored.
Also see Snapshots .
Recall Snapshot
This page of the “ UTILITY ” menu allows a Snapshot to be recalled.
Also see Snapshots and Aux Port .
Bandwidth Units
This page of the “UTILITY” menu allows the Bandwidth of Parametric Equalizers to be viewed and
adjusted in either Octaves or ‘Q’.
Aux Style
This page of the “ UTILITY ” menu allows the action of the Aux port to be viewed and adjusted.
Also see Aux Port .
ECO
This page of the “UTILITY” menu allows the device to save power by going into a low power mode
when it is not being used.
Standby is a fast mode which saves some energy, but will wake-­‐up very quickly if an audio input is
detected. The associated Standby Time parameter allows the amplifier to automatically go into
power-­‐save if no audio signal has been detected for a period of time. This function can be defeated
by setting the latter control to Manual. Linea would strongly advise leaving it set to automatic
however as there is no negative consequence to doing this since ‘wake-­‐up’ on detecting the
presence of an audio input signal is instantaneous.
The Standby Now ‘parameter’ allows the amplifier to be put into standby mode manually when it is
not being used.
Sleep is a deep power save mode which saves the most energy, however it will take a small number
of seconds for the amplifier to wake-­‐up, and it may only be woken up manually (either from the
PodWare application or by switching the device off then on again). The associated Sleep Time