Changes made
Changes Made
lists all parameters changed from default
settings.
•
The list shows only parameters which have been
changed in the current edit set-up.
•
Parameters which have been reset to default
values are not listed.
•
The message
Empty
indicates that no parameters
have been changed.
To change parameter settings
1.
Press [Menu] key to enter the Quick Menu until
indicator in display is placed above Quick Menu.
2.
Press [
▲
] [
▼
] to select wizard, closed-loop set-up,
compressor set-up or changes made, then press
[OK].
3.
Press [
▲
] [
▼
] to browse through the parameters
in the Quick Menu.
4.
Press [OK] to select a parameter.
5.
Press [
▲
] [
▼
] to change the value of a parameter
setting.
6.
Press [OK] to accept the change.
7.
Press either [Back] twice to enter Status, or press
[Menu] once to enter Main Menu.
The Main Menu accesses all parameters
1.
Press [Menu] until indicator in display is placed
above Main Menu.
2.
Press [
▲
] [
▼
] to browse through the parameter
groups.
3.
Press [Ok] to select a parameter group.
4.
Press [
▲
] [
▼
] to browse through the parameters
in the specific group.
5.
Press [Ok] to select the parameter.
6.
Press [
▲
] [
▼
] to set/change the parameter value.
Quick Guide
Quick Guide
22
Danfoss A/S © Rev. 08/2014 All rights reserved.
MG18M122
1
1
