MG.20.B6.02 – VLT is a registered Danfoss trademark
VLT
®
2000 Series
74
✭
= Factory setting. Text in ( ) = Display text. The figures in [ ] are used in bus communication.
Description of parameters
405 Terminal 29 Jog
(INPUT 29)
Value:
✭
Jog (JOG)
[0]
Start (START)
[1]
Digital reference (DIG.REF+START)
[2]
Pulse input, 100 Hz (PULSES 100 Hz)
[3]
Pulse input, 1 kHz (PULSES 1 kHz)
[4]
Pulse input, 10 kHz (PULSES 10 kHz)
[5]
Setup select (SETUP SELECT)
[6]
Reset (RESET)
[7]
Reversing (REVERSING)
[8]
Speed down (SPEED DOWN)
[9]
Function:
Using this parameter (terminal 29) you can give the
motor different signals.
Description:
You can set the output frequency to a pre-program-
med value (jog in parameter 203). Recording
Digital
reference
you can enable/disable values stored in
parameters 205-208.
If terminal 29 is used for either pulse signal reference
(open loop) or pulse signal feedback (closed loop),
choose one of the pulse inputs [3] - [5].
If
Multi setup
is selected in parameter 001, the termi-
nal can be used to switch between setups 1 and 2.
404 Terminal 27 stop
(INPUT 27) (continued)
Value:
Motor coasting (MTR.COASTnot)
[0]
Quick stop (Q-STOPnot)
[1]
DC-brake (DC-BRAKEnot)
[2]
✭
Reset and motor coasting (RESET&COASTnot) [3]
Stop (STOPnot)
[4]
Reset and start (RESET&START)
[5]
Speed up (SPEED UP)
[6]
Digital reference select (SPEED SELECT)
[7]
Speed up:
This is used together with parameter 230. It is
possible to make the output frequency increase
towards f
MAX
as long as 24 V is applied to terminal 18.
At 0 V on terminal 18 the output frequency in
question is maintained. See also parameter 403.
Digital reference select:
Together with parameter 402 you can choose
between four different digital references:
18/27
19
Terminal
0
0
Digital reference 1
1
0
Digital reference 2
0
1
Digital reference 3
1
1
Digital reference 4
■
■
