Dual potentiometer track selection
Minimum output
Voltage (% Vs)
Maximum output
Voltage (% Vs)
Switch track angle
Resistance kΩ
Order code
10 ± 2
90 ± 2
±1.5º
1.6 to 2.4
U
Hall effect sensor
The Hall effect sensor option includes dual sensors per axis. The sensors can be supplied from two
separate regulated 5 V supplies for a higher degree of redundancy, or can be supplied from a single
regulated 5 V supply.
Hall effect sensing electrical connections are made via a 12 pin AMP® 040 series MULTILOCK connector on
the base of the unit.
JS6000 Hall effect sensors are affected by temperature. Output values change temporarily by 2.6% and
permanently by 0.6% when subjected to a -40°C (-40°F) to 80°C (176°F) operating temperature range
cycle.
Hall effect sensor specifications
Supply voltage (Vs)
5 Vdc regulated
Minimum output voltage
10% ± 4% Vs
Center voltage
50% ± 2% Vs
Maximum output voltage
90% ± 4% Vs
Controller Area Network (CAN) output
Three versions of JS6000 CAN joysticks are available:
•
A grip
•
MG grip
•
HKN grip
CAN (configuration model code CAN)
CAN 2.0bB J1939 protocol and CANopen 2.0B J1939 protocol (reference
Code H: Electrical interface options
on page 19 product configuration model code, under
H1 electrical interface options
on page 19).
CAN+ (configuration model code CPL)
CAN+ output broadcasts joystick shaft position, grip switch states, grip proportional rocker position and
the state and value of up to 11 digital (DIN) or 7 digital (DIN) and 4 analog (AIN) inputs from sources
external to the joystick. The CAN+ option joystick base has an 18 pin DEUTSCH connector.
Pulse Width Modulated (PWM) output
One version of the JS6000 PWM joystick is available.
PWM (configuration model code PWM)
The PWM version of JS6000 joystick has two bi-directional PWM channels and six digital ouputs. The
PWM option joystick base has an 18 pin DEUTSCH connector.
Technical Information
JS6000 Joystick Base
Model code details
14
520L0760 • Rev 1102 • November 2015
