Installation and User Guide
DEVIreg™ Multi
FEC | Produced by Danfoss ©
26
Data for
CableOK?
function is presented on
=Channel data #X
screen, for example as on
the screen below in 3 bottom lines:
Relevant data on the picture above means the following:
-
CableOK?
function is disabled for
Channel #2
– ‘
Dis
’ on the screen, and software does
not control state of the input
DI2
;
- input
DI2
has setting ‘
NO
’ (Normally Open) or, in other words, when current flows
through the cable/heater the input
DI2
should not be closed on input
COM DI;
- actual status for
CableOK?
function is OK or displayed ‘
Yes
’ in the last line .
4.4.7
Channel ON/OFF – special function
Each
Active Channel
can be set up with status
OFF
or
ON
.
OFF
means that there is no
need to carry out
Channel
control algorithm due to, for example, a malfunction of the
cable or sensor, heating system installation and so on . In other words,
Channel
does not
perform algorithm and does not perform any
Alarms
. At the same time the
Channel
saves all settings and for
1S
mode active
Channels
show real sensors’ temperature and for
PR
mode – shows real mode time . Additionally, it is possible to do/change any settings .
Settings
Channel ON/OFF
function can be done by the following menu sequence:
EN: Main Screen – Enter to Main Menu – Channels settings – Channel #X – Channel
ON/OFF – {Enter – #X Channel ON/OFF }
EN: Main Screen – Enter to Main Menu – Channels settings – Channel #X – Channel
ON/OFF – {Enter – #X Channel ON/OFF }
When
Channel
is
OFF
hash sign/symbol – ‘
#
’ – is presented on the 2
nd
position of
Main
Screen
line, for example:
