Configuration -> Control -> LIGHT
Your AK-SM has the built in ability to support lighting scheules
and control via Danfoss I/O modules or via lighting panel
communications.
Typically the built in lighting control function is used to manage
general store lighting applications. The initial lighting configura-
tion is set out under the Configuration->Control page. The initial
control question asks how many lighting zones are required. The
AK-SM has the ability to share any indoor photocell configured
and to define how many photocells are required. Once these
initial control questions have been completed the remaining
configuration is done under the
Configuration->Control->Light.
Lighting control is done via built in AK-SM schedules, and the
optional use of photocells. The following section describes a
typical lighting configuration, using AK-SM control.
Detailed configuration is done under the Light
tab (Configuration->Control->Light)
The initial Lighting configuration is done
under the Configuration->Control page.
Danfoss recommends wiring any lighting circuits in
Normally Closed
position. This will ensure that if
power fails to the AK-SM or I/O modules the lighting
systems will ‘fail safe’ ‘ON’
Lighting Configuration
AK-SM Built in LIGHTING control (Using AK Input / Output /
schedules & Photocells)
The following control options can be seen in the Lighting tab,
navigate and press the enter key to change / configure any
relevant points.
52
User Guide
Lit. no.
USCO.PI.R1.E1.02 © Danfoss 07-2013
AK-SM
850