Danfoss AHF 010, Руководство по конструкции

Страница: 41 / 124

6 Programming
6.1 Parameter Descriptions
The parameters in this section are limited to the
parameters required for operating the VLT
®
Advanced
Harmonic Filter AHF 005/AHF 010. For reference to other
parameters, refer to the frequency converter programming
guide.
5-00 Digital I/O Mode
Digital inputs and programmed digital outputs are pre-
programmable for operation either in PNP or NPN systems.
Option: Function:
NOTICE
Perform a power cycle to
activate the parameter once it
has been changed.
[0]
*
PNP Action on positive directional pulses
(↕)
. PNP systems are pulled down
to GND.
[1] NPN Action on negative directional
pulses
(↕)
. NPN systems are pulled
up to +24 V, internally in the
frequency converter.
5-01 Terminal 27 Mode
Option: Function:
NOTICE
This parameter cannot be
adjusted while the motor is
running.
[0]
*
Input Defines terminal 27 as a digital
input.
[1] Output Defines terminal 27 as a digital
output.
5-02 Terminal 29 Mode
Option: Function:
NOTICE
This parameter is available for
FC 302 only.
[0]
*
Input Defines terminal 29 as a digital
input.
[1] Output Defines terminal 29 as a digital
output.
6.1.1 5-1* Digital Inputs
The digital inputs are used for selecting various functions
in the frequency converter.
Table 6.2 shows which functions
can be assigned to digital inputs.
Functions in group 1 have higher priority than functions in
group 2.
Group 1 Reset, coast stop, reset, and coast stop, quick stop,
DC brake, stop, and the [Off] key.
Group 2 Start, latched start, reversing, start reversing, jog,
and freeze output.
Table 6.1 Function Groups
Digital input function Select Terminal
No operation [0] All, terminal 32, 33
Reset [1] All
Coast inverse [2] All, terminal 27
Coast and reset inverse [3] All
Quick stop inverse [4] All
DC brake inverse [5] All
Stop inverse [6] All
Start [8] All, terminal 18
Latched start [9] All
Reversing [10] All, terminal 19
Start reversing [11] All
Enable start forward [12] All
Enable start reverse [13] All
Jog [14] All, terminal 29
Preset reference on [15] All
Preset ref bit 0 [16] All
Preset ref bit 1 [17] All
Preset ref bit 2 [18] All
Freeze reference [19] All
Freeze output [20] All
Speed up [21] All
Speed down [22] All
Set-up select bit 0 [23] All
Set-up select bit 1 [24] All
Precise stop inverse [26] 18, 19
Precise start, stop [27] 18, 19
Catch up [28] All
Slow down [29] All
Counter input [30] 29, 33
Pulse input edge
triggered [31] 29, 33
Pulse input time based [32] 29, 33
Ramp bit 0 [34] All
Ramp bit 1 [35] All
Programming Design Guide
MG80C602 Danfoss A/S © 05/2019 All rights reserved. 39
6 6