Dane Technologies, Inc.
QuicKART
Owners Manual
54
7105 Northland Terrace, Minneapolis, MN 55428 / 888-544-7779 / 763-544-7779 / Fax 763-544-4234
www.danetechnologies.com
970-047
REV
B 2-9-09
DEMONSTRATION TRAINING SCRIPT:
Show How To Turn The
In order to start the machine the key switch located
Machine On:
on the control panel is turned clockwise.
Perform Actual Inspection
As indicated in our training; check tire wear, check that
of QuicKART:
flashing light works, check charge level, and check
braking before moving off.
Show the Location of
With the machine set in the Manual Mode by twisting the
The Throttle:
thumb wheel throttle (nudge switch on M3 E) the
machine will move forward.
Drive Machine to Cart
If you will follow me as I drive over to the cart corral I will
Corral:
continue to show you how the machine operates.
Explain How to Connect
In order to connect a shopping cart to the QuicKART,
Cart to Cart Coupler:
lift up on the rear of the cart and slide the rear wheels
into the cart cups or slide rear legs of the cart into slots
on the cart coupler and place the clevis pins or locking
pin in the closed position so that it securely holds the
shopping cart in place.
Remote Control Transmitter:
At this point rotate the keyswitch to “Radio” the
QuicKART Control Panel.
Note:
As a safety feature,
rotate the keyswitch to “Off for 1 second before rotating to
“Radio”. Rotating the keyswitch immediately from “Manual” to
“Radio” or back may cause a fault and require the keyswitch
be turned “Off” for 1 second.
Collect carts and nest them into the cart/chain of carts
on the front of the QuicKART.
Explain and Physically
While standing to the side of the lead cart, put your
Direct Carts to Next Cart
thumb over the turtle switch on the hand held
Corral:
remote control. Press turtle to start the chain of carts
moving forward and quickly slide your finger over to the
rabbit switch to increase the speed of the machine as
conditions permit. On the M3 E the remote has forward
and reverse controls. The reverse slow (single arrow)
can be used while pushing the cart chain backward to
give clearance to a customer.
Stopping:
As you approach your destination, slide your finger back
to the turtle button or just let your finger off the button.
Remember that you need to hold back the lead cart
since you are acting as the brake for the chain of carts.
Quick Stop:
To make the QuicKART stop faster you can press the
stop button on the remote control. However, you will still
need to hold back the carts.
Collect Maximum of
We continue to add up to 30 carts. If the slope of the lot
30 Carts:
is steep or snow or ice has accumulated, limit the carts
to a manageable number.
Proceed to Cart Room:
Since we now have a large chain of carts we will
proceed back to the cart room.
Show and Explain How
Now that we are just outside the cart room, we need to
