Dane Technologies, Inc.
QuicKART
Owners Manual
5
7105 Northland Terrace, Minneapolis, MN 55428 / 888-544-7779 / 763-544-7779 / Fax 763-544-4234
www.danetechnologies.com
970-047
REV
B 2-9-09
Each hand-held remote control transmitter operates on a unique pre-programmed code.
For the QuicKART to operate in the Radio Mode, the receiver, which is under the hood,
must be programmed to match the hand held transmitter, see page 35 for details. The
LED on the remote will start to flash red when the battery is running low, and then cease to
operate when the battery needs replacing. After battery replacement, the remote
needs
to be reprogrammed
; see page 35 for details.
QUICKART M3, M3 E, M3 HD WARNINGS & SAFETY NOTES
Please read and understand all the information included in this manual and the service
instructions prior to operating or servicing the QuicKART. In addition, make certain all
operators have been given and passed the certified operators course before using the
QuicKART.
IMPORTANT SAFETY NOTE:
THE RED BATTERY PLUG MUST BE DISCONNECTED FROM THE BATTERIES
ANY TIME MAINTENANCE IS BEING PERFORMED UNDER THE COVER
1. The QuicKART is designed to push shopping carts. Any other use of the QuicKART
is prohibited unless specifically endorsed by the manufacturer. Improper usage and
operation of the QuicKART may void the warranty.
2. Federal regulations require that you be at least 16 years old to operate powered
equipment.
3. Do not operate the QuicKART unless you meet the minimum operator requirements
set down by federal and state regulations, and corporate policy.
4. Do not operate the QuicKART unless you have reviewed and understood the
training materials provided by your employer, passed the QuicKART test included in
the QuicKART operators manual, and have demonstrated the skills necessary to
operate the QuicKART safely.
5. Never carry passengers on the QuicKART M3, M3 E, or M3 HD!
6. The QuicKART is equipped with a brake that automatically engages when the
machine is turned off or not in motion. To avoid an accident,
do not leave the
machine parked or unattended on slopes.
When the QuicKART is to be left
unattended or in storage, turn it “OFF” and remove the key.
7. Do not use long extension cords. Use the cord supplied with the machine. Find a
location for recharging that is close to an electrical outlet receptacle. If another cord
must be used, it must be 16 gauge or larger and no more than 10 feet in length.
8. Do not plug more than one machine into an extension cord or electrical outlet
receptacle, use one outlet for each machine.
9. Do not leave the QuicKART unattended while it is turned “ON”.
10. Operate the QuicKART at a safe speed; go only as fast as safety considerations
allow. Take into consideration the location of store entrances, sidewalks,
pedestrian and vehicle traffic, driveways, and parking lot layout.
11. Always operate in slow speed when near store guests. Operating conditions, such
as wet or slippery pavement or slopes can affect the stopping distance of the
QuicKART. Do not push more carts than the individual operator can safely control
