AIRMATE-USB manual page: 5
SPECIAL AVAILABLE OPTIONS ON MODULE 1 TO 4
On the input PCB of your AIRMATE-USB are several jumpers that can be changed to enable different
configurations of the channel settings.
We advise to have this done by your local dealer if the need arises.
The following 7 jumper settings can be changed to adjust the Airmate-USB to your needs.
1
J12-13
R.I.A.A. correction amp PCB can be inserted on Jumper J12 and J13.
2
J3
Low cut filter on Mic input only by shorting all 4 pins on Jumper J3.
3
J15
48 volt phantom power on/off via Jumper J15.
4
J6/16
Stereo Aux send pre or post selectable via Jumper J6/16 (post is default).
5
J7
Clean-Feed (CLN-FEED) jumper (J7) to select whether the audio stereo signal
(summed to mono) is send to the clean-feed bus that is available in the master section
for connection external Hybrids.
6
J17
Pulse/continuous Jumper J17 to change the start pulse from latching (continuously) to
pulse.
7
J5
Mic gain ( Jumper J5) can be set to amplify an extra 20dB to 40dB.
