AIRMATE-USB manual page: 13
TAPE OUTPUTS
The first connectors on the left are the tape output connectors for left and right for connecting an audio
recorder. Output level is -10dBv (300mV), the signal is pre master fader.
CLEANFEED OUTPUTS
Direct beneath the Tape outputs are the Clean feed cinch connectors.
RED LIGHT
Direct beneath the Clean feed cinch connectors is a stereo jack (Mic On) that can control a red light
indicator. This stereo jack is connected to a change over relay. This relay is capable of controlling external
Red light circuits as long as it does not take a higher voltage than 24 volt and the current does not exceed
50mA!
NEVER CONNECT 220 VOLT AC TO THIS JACK!!
The C.C. (Center Contact) of the internal relay is connected to the Tip of the stereo jack.
The N.O. (Normally Open) contact is connected to the ring of the jack.
The N.C. (Normally Closed) contact is connected to the "ground" of the jack.
AIRMATE-USB RED LIGHT CONNECTION
AUX RETURN
Right from the tape connectors you see the Aux return connectors. These inputs are controlled by the Aux
return knob. The signal is directly connected to the master main mix busses. You can connect reverb
returns or other stereo signals without using any input module. The input level should -10dBv as a
minimum.
AUX OUTPUTS
The aux outputs are on two Cinch connectors providing you with the signal coming from the aux sends in the
channels.
The level is +4dBu (1.22 volt).
You can connect inputs from reverbs to these Cinch connectors or use it as a monitor output, when you have
jumpered the Aux send in the channels pre fader.
