Arrays and assembly procedures
3. Attach the first TOP cabinet to the Adapter frame
To attach the first cabinet to the frame, proceed as follows:
1. Lift the assembly to a suitable working height.
2. Prepare the Front and Splay links of the first cabinet as
described in .
3. With the front grill facing upwards, attach the prepared
cabinet to the corresponding slots at the front of the frame.
4. Reinsert the Locking pins on both sides.
5. Release the Rear link of the frame from its park position and
reinsert the Locking pin.
6. Raise the bottom cabinet until the Splay link of the frame has
engaged into the preset Locking pin (
[0°] hole) of the
cabinet.
7. Insert the second Locking pin (Safety pin
[S]) into the [2°]
hole.
4. Add further TOP cabinets
To add further cabinets, proceed in the same manner as described
in , until the assembly is completed.
5. Check the assembly
Before hoisting the array to its operating position, recheck the
actual status of the entire assembly according to the check list
given in .
6. Rig the cabling
Connect the cables and link cables according to the number of
amplifier channels and cabinets used.
▪ If the amplifiers are already wired and powered on, use their
System check functions or Channel mute switches and a test
signal to check the correct operation and routing of all channels
and cabinets.
▪ Alternatively, check the wiring using the Array verification
function in R1.
d&b Z5778/Z5779 Rigging manual 1.2 en
23
