27
26
Manual
Manual
DOORS AND GATES ASSEMBLY
Arrangement
of angles for
fastening
of
polycarbonate
on the doors.
Fig. 9.2
Install honeycomb polycarbonate with a specified side facing outwards
(sunward); this side has a covering layer (make sure to clarify it on
buying or prior to installation). Covering layer is usually placed on the
side with notations on the shipping film. The film is transparent on the
opposite side of a sheet. After marking the sheet but prior to cutting it,
mark the side with the covering layer on each piece of the sheet: when
the shipping film is removed sheet sides look the same. Shipping film
shall be removed from the both sides immediately before fastening
covering on the frame.
STAGE 10
Installation of covering
Install covering after fixing the frame on the ground. It is better to cut
the sheets using a fret saw or a fine-pitch arm saw.
CUTTING LIST OF COVERING OF AN END
Layout of pieces of covering of the end.
4
2
5
6
3
7
5
1
1
4
Fig. 10.1
PLACE PIECES OF COVERING ON THE END
KEEPING VERTICAL DIRECTION OF HONEY
COMBS.
