INSTALLATION INSTRUCTIONS
3
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior
to installation. Remove the packing box and
list the washer up and away from the foam
base cushion. Remove the accessories and the
protective foam from the inside of the cabinet.
Ensure that you do not throw away the noise
proof plate on the top of the packaging.
• Wipe the outside of the appliance with a soft,
dry cloth and the inside with a lukewarm wet
cloth. Do not spray the appliance with water.
• Place the appliance on a level fl oor that is strong
enough to support it when it is fully loaded,
in a room that has convenient access to a
water supply and drain, has low moisture and
humidity and does not freeze in winter.
• Do not place the appliance on carpeted fl ooring
as this can block the lower ventilation openings.
• Keep the appliance away from heat sources and
out of direct sunlight. Excessive heat or sunlight
can deform or discolour the appliance.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled such as garages, porches, vehicles,
etc, because water lines may freeze.
DIMENSIONS
The dimensions of this appliance are 60.1 cm (23.7
inches) wide, 63 cm (24.8 inches) deep, 100 cm
(39.4 inches) tall with the lid closed and 143 cm
(56.3 inches) tall with the lid open.
This appliance requires at least 2.5 cm (1 inch) of
space on both sides, 15.2 cm (6 inches) of space at
the back, 5 cm (2 inches) of space at the front and
at least 61 cm (24 inches) of space above to allow
room for the lid to open.
FEATURES
1. Lid
2. Control panel
3. Water inlet
4. Drain hose
5. Power cord
6. Water pump fi lter
7. Rollers
7
1
2
3
4
5
6
7
LEVELING INSTRUCTIONS
It is important that the appliance is level to help
avoid unbalanced loads and excessive noise.
The leveling foot is located on the front right side of
the appliance. There is a solid foot on the front left
side of the appliance and there are two rollers on
the back.
1. Turn the leveling foot counter-clockwise until
the top of the foot is touching the bottom of the
cabinet.
2. Slowly turn the leveling foot clockwise until the
appliance is level.
