Kollmorgen
Read Before Installing
SERVO
STAR
®
SP3 Power Block
1
READ BEFORE INSTALLING
This manual is provided with your product to assist you in getting your SERVO
STAR
®
SP3
Power Block installed and operational.
High voltage can be hazardous to personnel and equipment. Be sure a qualified
electrician works on this equipment. To ensure safety, follow all national and local
codes during installation as well as the safety precautions outlined in the front of
this documentation.
1.
Open the box(es) and remove all the contents. Check to ensure there is no visible damage
to any of the equipment.
2.
Mount the SP3 Power Block to the back panel. Refer to the Outline Dimensions for
additional details.
Metal-to-metal contact is important for electrical noise control!
3.
Wire the SP3 Power Block according to the System Wiring Diagram. Pay particular
attention to the pinout connector details.
4.
Connect solid earth ground to frames of all components.
5.
Wire the main power (24 VDC).
6.
Wire the motor and feedback. Refer to the Feedback Wiring Diagram for additional
information.
7.
Wire the Regen Resistor kit, if applicable.
8.
Verify that all wiring is correct.
9.
Verify that earth grounds are connected.
10.
Verify all electrical and safety codes are met.
11.
For the integrated 8F option:
A.
Connect the halls cable to connector C1.
B.
Connect the feedback connector C2.
C.
Connect the connector C3 to PMAC (The SP3 works with the standard PMAC
motion controller).
D.
Connect the user flags connector C4.
E.
Connect the user flags connector C5.
www.szcxi.com | From
：
KOLLMORGEN
