Piranha HN RoHS User Manual
03-032-20135-00
Teledyne DALSA
52
Notes:
•
If
x2
x1
then
x2
is forced to be
x1
.
•
Analog gain, analog offset, digital offset, background subtract, and digital system
gain are applied to the data. FPN and PRNU coefficients are not included in the
data.
•
Values returned are in 12 bit DN.
•
Available in TDI Mode only.
Related Commands: css, roi
Example:
gla 10 20
Temperature Measurement
The temperature of the camera can be determined by using the
vt
command. This command will return
the internal chip temperature in degrees Celsius. For proper operation, this value should not exceed 75°C.
Note:
If the camera reaches 75°C, the camera
will shut down and the LED will flash red
. If this occurs,
the camera
must be rebooted
using the command,
rc
or can be powered down manually. You will have
to correct the temperature problem or the camera will shut down again.
Voltage Measurement
The command
vv
displays the camera’s input voltage. Note that the voltage measurement feature of the
camera provides only approximate results (typically within 10%). The measurement should not be used
to set the applied voltage to the camera but only used as a test to isolate gross problems with the supply
voltage.
Camera Frequency Measurement
Purpose:
Returns the frequency for the requested Camera Link control signal
Syntax:
gsf m
Syntax Elements:
Camera Link control signal to measure:
1: CC1 (EXSYNC)
3: Direction
Example:
gsf
Returning Camera Settings
Returning All Camera Settings with the Camera Parameter
Screen
The camera parameter (
gcp
) screen returns all of the camera’s current settings.
To read all current camera settings, use the command:
Syntax:
gcp
≤
