15
3.4
Quick start
3.4.1
Get a thermal image
After installing the battery, press and hold the camera power switch (more than 3
seconds) until the power light turns green. After about 15 seconds, the instrument is
initialized and enters the working state.
Open the lens cover, aim at the target, and use the focusing wheel to focus the thermal
imager, so that the target image is clear.
Double-tap the screen to autofocus the camera.
! Note: The focus is not clear, which may lead to measurement errors.
3.4.2
Temperature Measure
Move the cross temperature measuring point in the screen to the target object, and the
"XX" displayed in the upper left corner of the screen is the temperature of the target at the
temperature measuring point. See "4.2 Temperature Measurement Mode" for details of
adding temperature measurement objects.
If you want to measure the temperature of the current thermal image displayed on the
screen in detail, you can store the thermal image for further analysis.
When the target temperature is higher or lower than the upper or lower limit temperature
corresponding to the temperature measurement position of the thermal imager, the screen
temperature will display > XXX
℃ or < X X X ℃ to prompt the user.
If you need to set the attribute of the temperature measurement object, click the object on
the touch screen to select it, and then press the setting icon at the bottom right of the screen
to enter the attribute setting menu of the temperature measurement object. After setting,
click the arrow at the top left corner of the screen to return to the active image. The
following are the attribute setting menus of temperature measuring point, temperature
measuring line and temperature measuring area:
