Display Installation
5
Display Installation
1.
Use a utility knife to carefully cut away all of the white packaging material from the
display. Be careful not to damage the face of the display or LEDs.
2.
If the display is multi-sectional, refer to the
section
before
continuing.
3.
Attach a crane or lift truck to the lift eyes on the display’s top.
4.
Apply tension to the lift
lines.
5.
Attach tag lines to the
bracket.
6.
Unbolt the display from
the shipping braces.
7.
Lift the display off the
truck to the display
structure.
8.
Mount the display to the
structure by welding or
bolting all T-Clips to
horizontal stringers.
9.
Remove crane support and tag lines from the display once mounting is complete.
10.
Locate the top border caps and install over lift eyes using provided Tek screws.
Figure 1:
Proper Display Lifting
From Back
Tag Line
Tie Off
Angle must be
greater than 55°
Lift-Eye Bolts
Set Bolts
Note:
Lift eye spacing is set at Daktronics and should not be moved. Lift eyes
should also remain in place after installation is complete.
Note:
Ensure the angle between the top of the display and the lifting strap is
greater than 55 degrees, as shown in
.
Note:
Do not lift
displays in
wind speeds
greater
than 20
mph.
Note:
Use all
T-Clips when
mounting
the display.
Note:
The T-Clips are installed in the recommended locations at Daktronics, but
can be moved 12 inches either way to avoid obstructions. Refer to the label
on the display for limitations.
Содержание VANGUARD VC6
Страница 4: ......