Daktronics SW-2001, Руководство пользователя

Страница: 17 / 88

Electrical Installation
13
Wireless Signal Connection
Reference Drawings:
Aquatics- Radio Hookup ................................................................................... DWG-305509
A wireless radio system requires an OmniSport 2000 control console equipped with
a radio transmitter as well as a radio receiver plugged into the 6-pin J21 jack on the
primary driver and mounted internally to the front panel of the display. Refer to DWG-
305509 in Appendix B for radio receiver installation instructions for both indoor and
outdoor scoreboard models. For more information, refer to the Gen VI Radio Installation
Manual (DD2362277) , provided with the receiver unit and available online at www.
daktronics.com/manuals .
Internal Cable Routing (Horizontal Models Only)
Reference Drawings:
Internal Cable Routing ....................................................................................... DWG-130679
Horizontal, or side-by-side, modules require installation of a power/signal interconnect
cable. Only one interconnect cable is needed for each installation. Refer to DWG-
130679 .
Connect the modules by running the interconnect cable from the driver of the bottom
left module to the driver of the bottom right module. There are knockouts in the ends of
the modules through which the cable may be run. The cable is connected with mating
5-pin plugs in each module.
Setting the Driver Address
Each driver in a scoreboard module must be set
to receive the correct signal input, or address, for
the control system being used.
Addresses are set through the S2 (L) and S3 (H)
rotary switches on the driver ( Figure 8 ) using a
small flathead screwdriver.
Refer to the tables on the following pages to
determine the correct driver address settings
based on the control system in use.
H
L
Figure 8: Driver Address Dials