Daktronics SPORTSOUND 500HD, Руководство по установке

Страница: 14 / 58

Electrical Installation
10
Grounding
All components of an audio system – including but not limited to control equipment,
and connected peripheral equipment – must be electrically grounded. Only qualified
individuals may perform electrical work, including verification of ground resistance.
Daktronics is not responsible for improper grounding or damage incurred as a result of
improper grounding.
Grounding methods must meet the provisions of all applicable local and national codes.
Inspect and verify all grounding methods meet the provisions of all applicable local and
national codes.
Proper grounding is necessary for reliable equipment operation and general electrical
safety. Failure to properly ground the sound system may void the warranty, disrupt
operation, damage equipment, and cause bodily harm or death.
Lightning Protection
The use of a disconnect near the system to completely cut all current-carrying lines
significantly protects the circuits against lightning damage. In order for this device to
provide protection, the power must be disconnected when the system is not in use.
Fiber Conversion Box Connections
Reference Drawings:
System Riser; 500HD ............................................................................................ DWG-980598
Audio; Sportsound, Fiber Box Schematic ....................................................... DWG-1095894
IMPORTANT NOTES:
• The fiber box shall not be exposed to dripping or splashing, and no objects filled with
liquid shall be placed on the fiber box.
• The fiber box consists of Class 1 construction and shall be connected to a mains
socket outlet with a protective earth-ground connection.
• The fiber box utilizes a power cord with wiring inlet as a means for disconnection from
power. This means of disconnection shall remain readily operable in all cases.
Refer to Figure 14 for external fiber conversion box connections and Figure 15 for internal
connections and component locations. Note that the fiber box is not included in analog-
only systems.
Refer to Detail “C” in
DWG-980598 for analog backup connection and Detail “D” for fiber
connection. DWG-1095894 provides a detailed wiring schematic.
120/240 VAC
Power IN
Fiber & Analog OUT
(To Control Enclosure)
XLR Audio IN
(From Source)
Figure 14: External Fiber Conversion Box Connections