Daktronics Galaxy AF-3200 Series, Руководство пользователя

Страница: 18 / 79

4. Mate-n-Lok
™
Connectors:
The white Mate-n-Lok connectors found in the
displays come in a variety of sizes.
Figure 11
illustrates a five-pin Mate-n-Lok connector. To
remove the plug from the jack, squeeze the plastic
locking clasps on the side of the plug and pull it from
the jack.
Figure 11: Mate-
N-Lok Connector
5.
Fiber Optic Connectors:
A fiber optic cable has a “twist-on” connector at each
end. To remove the fiber plug, push it toward the
board and twist it counter-clockwise until you can pull
the plug from the jack.
Figure 12
shows this connector.
Figure 12: Fiber Optic Cable
6. RJ11/RJ45 Connectors:
RJ connectors, as seen in
Figure 13
, are similar to the
telephone and LAN connectors found in homes and
businesses. In order to remove this plug from the jack,
depress the small clip on the underside of the plug.
Figure 13: RJ45
Connector
Before replacing an RJ connector, spray it with
DeoxIT
™
contact cleaner to remove any foreign matter
that may cause signal problems. In addition, apply a
generous amount of CaiLube
™
protector paste to the
plug before inserting it into the jack. This paste will
protect both the plug and the jack from corrosion.
7. Quick Connect Jack:
The display uses quick connect jacks for the
connection of the signal termination enclosure, and the
temperature sensor. There are three input and one
output quick connect jacks located on the back of
the primary display, and when not used the attached
dust cover should be kept closed.
Figure 14: RS232/6-pin
Quick Connect Jack
To attach the cable to a jack, make sure to line up
the plug to match the jack, push the plug in, then
turn the outer collar to lock in place.
Figure 14
illustrates the 6-pin quick connect jack.
Electrical Installation
3-2