TROUBLE SHOOTING GUIDE
IMPORTANT: Make sure to always disconnect the negative cable from the battery if you are
going to be working on or under the vehicle. Failure to do so can result in serious injury if the
system is accidentally activated.
Symptom
Possible
Problem
Solution
----------------------------------------------------------------------------------------------------------------------------------------------------
System will not operate any of the
Receiver is not getting
Check 12 volt connection.
solenoids.
power.
Check
ground
connection.
Check fuses.
Ignition
key
is
on.
Turn
off
ignition.
Accessory input is powered
Check connection to Acc. wire.
Remote module is not plugged in.
Connect connections.
System is in display test mode
Check Switch #4
Air solenoids ‘jump’
Weak or poor 12 volt connection.
Check 12 volt connection.
or
‘chatter’.
Move
to
new
terminal
point.
Bags change direction in
Over loaded 12 volt power circuit.
Place receiver and windows on
mid-travel.
separate
circuits.
Check for loose connections.
Increase wire size on power.
Weak
car
battery.
Recharge
or
replace
car
battery.
Transmitter signal is being disrupted.
Move antenna away from power
wires.
Transmitter has very short range
Transmitter battery is weak.
See Battery Replacement.
on all functions.
Antenna needs repositioning
Move antenna out away from
any high current wires.
When the system is ready to receive a transmitter signal, the green light should be flashing slowly. If it is not, begin
checking the power and ground connections.
If none of these solutions solve the problem, or the problem occurring is not listed here, please call the Dakota
Digital technical assistance line at (605) 332-6513 for further assistance or email to
[email protected].
4510 W. 61
st
St. N.
Sioux Falls, SD 57107
Phone: (605) 332-6513
FAX: (605) 339-4106
5
