OPERATION AS REMOTE CONTROL SYSTEM
The remote system is active when the large red power wire has power and the accessory power
wire does not. This prevents accidental operation using the remote system while the vehicle is
being driven. When the remote system is ready and waiting to operate the green light by the
programming switches will be flashing slowly. If a display module is also connected, then when
a transmitter button is activated the display will come on and show what the current control
operation is.
There are two modes of operation for the transmitter.
1
Left Front Up/Down
Left Rear Up/Down
3
2
Right Front Up/Down
Right Rear Up/Down
All Up/Down
4
OPERATION FOR MODE 1, DIP switch #2 OFF
The key chain transmitter has four buttons. They are referred to below as button 1, 2, 3,
and 4. Buttons 1 and 2 are on the top, to the right and left of the green light. Buttons 3 and 4
are below.
Button 1 controls the left front bag. The first time it is pressed it will release air from the
bag until the button is released. The next time it is pressed it add air into the bag until it is
released. Button 2 controls the right front bag, button 3 controls the left rear bag, and button 4
controls the right rear bag. They works the same as button 1, reversing the bag direction each
time it is pressed.
Button 1 and 3 pressed at the same time will controls all four bags at the same time. The
first time the button is pressed it will lower all of the bags until it is released. The next time it is
pressed it will raise all of the bags until it is released.
2
