Dake SE-712, Инструкция по эксплуатации

Страница: 5 / 34

- 4 -
B. USE OF MACHINE:
(1). REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that
keys and adjusting wrenches are removed from tool before turning it "on".
(2).
DON'T FORCE TOOL. It will do the job better and be safer at the rate for which it
was designed.
(3).
USE RIGHT TOOL. Don't force tool or attachment to do a job for which it was not
designed.
(4).
SECURE WORK. Use clamps or a vise to hold work when practical. It's safer than
using your hand frees both hands to operate tool.
(5).
MAINTAIN TOOLS IN TOP CONDITION . Keep tools sharp and clean for best and
safest performance. Follow instructions for lubricating and changing accessories.
(6).
USE RECOMMENDED ACCESSORIES. Consult the owner's manual for
recommended accessories. The use of improper accessories may cause hazards.
(7).
AVOID ACCIDENTAL STARTING. Make sure switch is in “ OFF” position before
plugging in power cord.
(8). DIRECTIONOF FEED . Feed work into a blade or cutter against the direction of
rotation of the blade or cutter only.
(9). ADJUST AND POSITION the blade guide arm before starting the cut.
(10). KEEP BLADE GUIDE ARM TIGHT , A loose blade guide arm will affect sawing
accuracy .
(11). MAKE SURE blade speed is set correctly for material being cut.
(12). CHECK for proper blade size and type.
(13). STOP the machine before putting material in the vise.
(14). ALWAYS have stock firmly clamped in vise before starting cut.
(15).
GROUNDALL TOOLS
. If tool is equipped with three-prong plug, it should be
plugged into a three-hole electrical receptacle. If an adapter is used to accommodate
atwoprong receptacle, the adapter lug must be attached to a known ground. Never
removed the third prong.
C. ADJUSTMENT :
MAKE all adjustments with the power off. In order to obtain the machine. precision and
correct ways of adjustment while assembling, the user should read the detailed
instruction in this manual.
D. WORKING ENVIRONMENT:
(1). KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
(2). DON'T USE IN DANGEROUS ENVIRONMENT. Don't use power tools in damp or