Dake SE-712, Инструкция по эксплуатации

Страница: 18 / 34

- 17 -
(3). Loosen the hex head screw in the tilting machanism to a point where it is loose but
snug.
(4). With the machine running, adjust both the set crew and blade tension knob
simultaneously to keep constant tension on the blade. The set screw and blade
tension knob are always turned in opposite directions, ie, when one is turned
clockwise the other is turned counterclockwise.
The blade is tracking properly when the back side just touches the shoulder of pulley
or a slight gap appears near the center line of the pulley. Care should be taken not to
over-tighten the saw blade since this will give a false adjustment and limit life of the
blade.
(5). Tighten the hex head screw in tilting mechanism. IMPORTANT: Sometimes in trying
to make this critical adjustment it is possible to cause the basic setting to be
misaligned. Should this occur, proceed as follows:
a. Loosen the set screw and back it out as far as it can go and still remain in the
threaded hole.
b. Turn the hex head screw clockwise until it stops (do not tighten).
c. Turn the set screw clockwise until it bottoms, then continue for half a turn and
check the tracking by turning on the machine.
d. If further adjustment is required, go back to step 4.
(6). Turn off power to the machine.
(7). Replace the clade guide assemblies--it may be necessary to loosen the blade
tension alightly.
(8). Adjust the vertical position of blade guide bearing assemblies so that the back side of
the blade just touches the ball bearing.
(9). Make a final run to check tracking. It required, touch up adjustment (See stop 4)
(10). Replace the blade guards.
10. MAINTENANCE
CAUTION: MAKE CERTAIN THAT THE UNIT IS DISCONNECTED FROM THE POWER
SOURCE BEFORE ATTEMPTING TO SE RV ICE OR REMOVE ANY COMPONENT.
That's easier to keep machine in good condition or best performance by means of
maintaining it at any time than remedy it after it is out of order.
(1) Daily Maintenance (by operator)
(a) Fill the lubricant before starting machine everyday.
(b) If the temperature of spindle caused over-heating or strange noise, stop machine
immediately to cheek it for keeping accurate performance.
(c) Keep work area clean; release vise, cutter, work-piece from table; switch off power
source; take chip or dust away from machine and follow instructions lubrication or