8
For better performance, install a 3/8 inch quick plug(1/4
inch NPT threads) with an inside diameter of 0.315 inch
(8mm) on the nailer and a 3/8 inch quick coupler on the air
hose.
With trigger locker in lock position, plug compressor
into electrical outlet.
Close pressure regulator by turning all the way to the
left. Turn compressor ON and let it pump all the way up
to automatic shut-off pressure.
Attach air hose to regulator outlet. Adjust pressure
regulator by turning to the right so that outlet pressure is
between 70PSI to 115PSI.
Load fasteners into nailer.
Point the nailer in a safe direction while attaching to air
hose.
Turn the trigger locker in untook position.
Nailer is ready for use. You may need to adjust outlet
pressure to achieve proper fastener depth.
1.
2.
3.
4.
5.
6.
RECOMMENDED
HOOKUP
MINIMUM COMPONENTS
REQUIRED FOR HOOKUP
Air compressor:
Air supply hose:
The air compressor must be able to
maintain a minimum of 70PSI when the nailer is being
used. An inadequate air supply can cause a loss of power
and inconsistent driving.
Pressure regulator: A pressure regulator is required to
control the operating pressure of the nailer between 70PSI
and 115PSI .
Always use air supply hoses with a
minimum working pressure rating equal to or greater than
the pressure from the power source, or 150PSI, whichever
is greater. Use 1/4 inch air hose for runs up to 50 feet. Use
3/8 inch air hose for 50 feet, run or longer.
When cleaning a tool be careful not to disassembly any
portion of the tool since internal components may be
misplaced or safety components may be improperly
mounted.
Certain cleaning agents such as gasoline, carbon
tetrachloride, ammonia. etc. may damage plastic parts and
o-rings.
CLEANING
WARNING
MAINTENANCE
Do not attempt to clean by inserting pointed objects through
openings.
.
Sharp edges may damage internal components
causing a serious hazard.
Ventilation openings, the work contact element, and the
trigger must be kept clean and free of foreign matter
Clean the magazine. Remove metal or wooden chips which
may have accumulated in the magazine. Periodically clean
magazine with compressed air.
WARNING
STORAGE
HOOKUP INSTRUCTIONS FOR
TOOL TO AIR SUPPLY
When not in use, the tool should be disconnected and
stored in the storage case in a warm and dry place. When
Keep out of reach of children and personnel unfamiliar with
tool operation.
Lock the storage area. Tools are dangerous
in the hands of personnel unfamiliar with the tool.
WARNING
TRIGGER LOCK
The nailer is equipped with a trigger locker C.
If it is in lock position, tool is restricted to work and be safe.
When it is in un-lock position, the tool is in work status.
C
FIG. 18
tool will not be in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
Do not store the tool in a cold weather environment.
