DAITEM SH710AX, Руководство по установке

Страница: 6 / 28

GB
142
3. Recognition programming
IMPORTANT
• During recognition programming, the product to be programmed for recognition does not need to be close to the control panel. In fact,
it is advisable to move it at least 2 metres away.
• The control panel issues three short beeps to indicate an error, the receiver issues three short beeps to indicate a programming error
and the green LED flashes. When this happens, perform recognition programming again from the start.
• The receiver and control panel must be in installation mode. The receiver is in installation mode when powered. Refer to the installation
manual for the control panel.
Briefly press the receiver
“test” button
Press and hold the
“Off” button on the
control panel until the
panel responds
10 s max.
“beep, device X”
)
)
)
)
)
SH710AX
A1250A04823
)
)
)
)
)
“beep” “beeep”
The control panel issues
a voice message to
indicate the receiver n° The receiver issues a
beep to validate
recognition programming
“beep, disarmed,
control panel”
Open the control panel cover and proceed as follows:
Next refer to chapter 4.1 Setting the parameters of a receiver recognised by a control panel.
3.1 Programming the receiver to be recognised by the control panel