DAITEM SH710AX, Руководство по установке

Страница: 24 / 28

GB
160
The control panel supervises and identifies the receiver. It
monitors the state of:
• the
power supply ,
• the radio link ,
• the anti-tamper contact .
If a fault has been memorised, the control panel issues a voice
message to indicate the fault following a system command.
The power fault is also indicated locally by the receiver as it
issues 3 short beeps .
Example: if the receiver/control panel radio link is lost, the
control panel issues
the voice message:
8. Maintenance
8.1 Fault indications
To change the battery:
8.2 Changing the battery
“beep, partially arm one,
beep, fault, radio link, device X”
1. Switch the system to installation mode using the control
panel to enter:
then
master code
installer code
2. Loosen the 4 cover screws and open the receiver.
“beep, test mode”
“beep, installation
mode”
“beep, test mode”
“beep, installation
mode”