DAITEM SH710AX, Руководство по установке

Страница: 13 / 28

GB
149
A maximum of 10 products of the same type (remote control, keypad, pendant or motion or door/window detector) can be
programmed for recognition on each output. The different products or control devices concerned must dispatch the same signal.
If several products have to be programmed for recognition on the same output, the parameter-setting procedure must be performed
for each product.
4.2 Setting the parameters of a receiver recognised by another product
To start the
procedure, press
and hold the
“test” button until
the LED goes out.
Press the “test”
button as many
times as is
required for the
selected output.
Output number
• output 1: press once
• output 2: press twice
• output 3: press 3 times
• output 4: press 4 times
• output 5: press 5 times
• output 6: press 6 times
• output 7: press 7 times
• output 8: press 8 times
Operating mode
• 1: disabled
• 2: On/Off
• 3: toggle switch
• 4: 1.3 s pulse mode (1)
• 5: 2.5 s pulse mode (2)
• 6: 10 s timer
• 7: 90 s timer
• 8: 3 min timer
• 9: 15 min timer
• 10: 30 min timer
IMPORTANT: before setting the receiver parameters, recognition programming must be performed (see 3.2 Programming a product to be
recognised by the receiver).
(1) For operating the Daitem gate control system of an automatic or semi-automatic gate (opening of one side only).
(2) For operating the Daitem gate control system of an automatic or semi-automatic gate (opening of both sides).
The receiver
issues a beep
to validate
parameter-
setting
“beeep”
Press and hold
the
“test”
button until the
LED goes out.
Press the “test”
button as many
times as is
required for the
operating mode.
To end the
procedure, press
and hold the
“test”
button until the
LED goes out.
)
)
)
)
)
• Move your hand in front of the infrared
detector lens or move the magnet away from
the door/window detector to trigger detection
• Or press and hold the button concerned on
the remote control or keypad (in installation
mode) or the pendant pushbutton.
• Or press and hold the test button on the
smoke detector
until the receiver responds
SH710AX
A1250A04823
SH710AX
A1250A04823
about 10 s
SH710AX
A1250A04823
SH710AX
A1250A04823
SH710AX
A1250A04823
about
5 s
about 10 s