GB
19
3. Recognition programming
IMPORTANT
• The device does not need to be placed close to the control panel for recognition programming. In fact, we advise you to move the
product at least 2 metres away from the control panel.
• The detector n° is allocated automatically by the control panel during recognition programming.
This operation allows the control panel to recognise the detector.
2.
Proceed as follows for recognition programming:
1.
For detector recognition programming, the control panel must be in installation mode. If it is not, ask the user to enter:
then
IMPORTANT: the control panel issues three short beeps to indicate a programming error. When this happens, programming must
be performed again from the beginning.
Press
*
then
#
on
the control panel
keypad.
Press and hold the
“test”
button until the control
panel responds.
Select the
group from 1 to
8*
. Use the control panel
keypad to do this.
Select the time delay:
0: immediate
1: delayed
2: combined
Use the control panel
keypad to do this.
The control panel
issues a voice
message to confirm
detector recognition
programming.
then
to
)
)
)
)
)
10 s max.
“detector X”
“group ?”
“time delay?”
*
to
* depending on the
type of control panel
master code (factory: 0000)
installer code (factory: 1111)
“beep, detector X,
group Y, immediate
(or delayed
or combined)”
“beep, installation
mode”
