GB
24
To set the detection zone:
1.
Remove the locking
mechanism using a
flat-headed
screwdriver. Carefully
insert the screwdriver
into the right-hand
and then left-hand
openings and push
upwards.
2.
Hold the detection module and
point it in the required direction
adjusting it 5° at a time.
4.
Reposition the locking mechanism to block the
detection module in its final location.
3.
For protection along a vertical surface (wall, bay window, etc.), it is advisable
to align the detection zone parallel with this surface:
• for improved detection,
• to reduce interference caused by this surface.
7.2 Adjusting the detection angle horizontally
IMPORTANT: check that the
locking mechanism is properly
inserted in the slots.
Detection zone setting range
Locking
mechanism
Top view
Setting range: 95°
(in 5° adjustments)
Setting range: 95°
(in 5° adjustments)
5° adjustments
The marks on the locking system help to achieve the
optimal adjustment in this configuration. Choose the
mark located on the opposite side of the surface
before repositioning the locking mechanism.
