DAINESE D-AIR STREET SMART CHEST Series, Информационная записка

Страница: 58 / 188

GB
D-Air ® Intelligent Protection System
GB
D-Air ® Intelligent Protection System
P. 56
Figure 2: electronic system
The electronic part is contained inside the back protector; it is powered by rechargeable batteries positioned inside it and controls
operation of the System in the garment.
The operating status is controlled by a remote switch on/switch off system, while the battery level can be checked using the user
interface LED.
●●
IMPORTANT: the electronic system housing is sealed by DAINESE during manufacture. Tampering with this seal invalidates the
product warranty. Do not tamper with and/or remove the electronic system. Contact the nearest DAINESE Service Centre in case of need.
3.1.2. User interface
The user interface is a small LED positioned on the right forearm. The purpose of the interface is to communicate the information
required by the user. Notes for the correct comprehension and use of the D-AIR STREET SMART CHEST user interface are provided below.
3.1.3. Airbag
The D-AIR STREET SMART CHEST incorporates an airbag that contains a high pressure gas canister for inflation of the airbag.
3.1.4. Batteries and battery life of the System
When completely charged, the system should be capable of staying on for around 8 hours of use. Whenever the rider makes no
significant movements for more than 5 minutes (static electronic system), the System automatically enters stand-by status in order to
minimize consumption. As soon as significant movements resume, the System switches back on.
The battery is not subject to memory effect, and therefore the System can be completely charged in any moment.
For more information on battery operation and charging, see paragraph 3.5. "Checking the battery charge level and charging".
3.1.5. USB battery charger
The D-AIR STREET SMART CHEST comes with a USB battery charger. This battery charger must be connected to a 100-240V 50 Hz current
socket.
Whenever such 100-240V 50-60Hz current socket is not available, the battery can be charged by using the USB cable to connect the
System directly to a computer.
Once the USB cable is connected to the charging source, the user interface LED will light up red. When 90% of the full charge has been
reached, the LED will turn green. When the system is fully charged, the LED will turn blue.
3.2. System on/off procedures
Make sure that the System's batteries are fully charged, the battery charge has a duration of around 8 hours; make sure that you charge
your D-AIR STREET SMART CHEST before the battery charge runs down completely.

After having put on your garment with D-AIR STREET SMART CHEST integrated correctly (see paragraphs above) and closed the zip
positioned on the abdomen completely, firmly close the switch on / switch off buttons as indicated in Figure 13 below.
Figure 3: switch on / switch off buttons
0412060321 N.I.P1 D-AIR STREET CH Rev.00_corpo.indd 56 06/10/2015 11:56:26