DAINESE D-AIR SKI EVOLUTION, Руководство по эксплуатации

Страница: 17 / 186

33
32
I N F O R M A T I V E N O T E F O R I N F L A T A B L E P R O T E C T O R S D - A I R ® S K I E V O L U T I O N
The electronic part is contained inside the back protector;
it is powered by rechargeable batteries positioned inside it
and controls operation of the System in the garment.
The operating status is controlled by a remote switch on/
switch off system, while the battery level can be checked
using the user interface LED.
IMPORTANT: the electronic system housing is sealed by
DAINESE during manufacture. Tampering with this seal
invalidates the product warranty. Do not tamper with
and/or remove the electronic system. Contact the nearest
DAINESE Service Centre in case of need.
3.1.2. USER INTERFACE
The user interface is a small LED mounted on the back
protector, in proximity of the on off switch. The purpose of
the interface is to communicate the information required
by the user. Notes for the correct comprehension and use
of the D-AIR SKI EVOLUTION user interface are provided
below.
3.1.3. AIRBAG
The D-AIR SKI EVOLUTION incorporates an airbag that
contains a high pressure gas canister for inflation of the
airbag.
3.1.4. BATTERIES AND BATTERY LIFE OF THE SYSTEM
When completely charged, the system should be
capable of staying on for around 8 hours of use.
Whenever the rider makes no significant movements
for more than 5 minutes (static electronic system),
the System automatically enters stand by status
in order to minimize consumption. As soon as
significant movements resume, the System switches
back on.
The battery is not subject to memory effect, and
therefore the System can be completely charged in
any moment.
For more information on battery operation and
charging, see paragraph 3.5. “Checking the battery
charge level and charging”.
3.1.5. USB BATTERY CHARGER
The D-AIR SKI EVOLUTION comes with a USB
battery charger. This battery charger must be
connected to a 100-240V 50-60Hz current socket.
Whenever such 100-240V 50-60Hz current socket
is not available, the battery can be charged by using
the USB cable to connect the System directly to a
computer.
Once the USB cable is connected to the charging
source, the user interface LED will light up red.
When 90% of the full charge has been reached,
the LED will turn green. When the system is fully
charged, the LED will turn blue.
WARNING!