Daikin Super Multi NX FTXS20G2V1B, Руководство по обслуживанию

Страница: 79 / 316

FTXS20/25/35/42/50G2V1B SiENBE04-808_A
67 System Configuration
„
To start 3-D Airflow
1. 3. Press the “SWING button ” and the “SWING button ”: the “ ” and
“ ” display will light up and the flap and louvers will move in turn.
„
To cancel 3-D Airflow
2. 4. Press either the “SWING button ” or the “SWING button ”.
„
COMFORT AIRFLOW operation
• Chack COMFORT AIRFLOW operation in the section of “COMFORT AIRFLOW Operation”
and “INTELLIGENT EYE Operation”.
Notes on flaps and louvers angles
• When “ SWING button ” is selected, the flaps swinging range
depends on the operation mode. (See the figure.)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates cold air, which tends
to collected at the bottom of the room, and hot air, which tends
to collect near the ceiling, throughout the room, preventing
areas of cold and hot developing.
„
ATTENTION
• Always use a remote control to adjust the angles of the flaps
and louvers. If you attempt to move it forcibly with hand when it
is swinging, the mechanism may be broken.
• Always use a remote control to adjust the louvers angles. In
side the air outlet, a fan is rotating at a high speed.
5°
80°
15°
50°
80°
30°
70°
Upper limit
COMFORT AIRFLOW 5°
COMFORT AIRFLOW
Lower limit
Stop operation
Upper limit
Lower limit
Upper limit
Lower limit
In HEAT mode
In FAN mode
Stop operation
Stop operation
In DRY mode or
COOL mode
SiENBE04-808_A.pdf 79 21/02/2011 13:19:57