Daikin OH08-1, Инструкция по эксплуатации

Страница: 52 / 150

Remote Controller (Wireless Type) OH08-1
50 Control Systems
See Fig. 1, 2
1
DISPLAY “ ” (SIGNAL TRANSMISSION)
This lights up when a signal is being transmitted.
2
DISPLAY “ ” “ ” “ ” “ ” “ ” (OPERATION MODE)
This display shows the current OPERATION MODE. For cooling only type, “ ” (Auto)
and “ ” (Heating) are not installed.
3
DISPLAY “ ” (SET TEMPERATURE)
This display shows the set temperature.
4
DISPLAY “ ” (PROGRAMMED TIME)
This display shows PROGRAMMED TIME of the system start or stop.
5
DISPLAY “ ” (AIR FLOW FLAP)
Refer to page 56.
6
DISPLAY “ ” “ ” “ ” (FAN SPEED)
The display shows the set fan speed.
7
DISPLAY “ ” (INSPECTION/ TEST OPERATION)
When the INSPECTION/TEST OPERATION BUTTON is pressed, the display shows the
system mode is in.
8
ON/OFF BUTTON
Press the button and the system will start. Press the button again and the system will stop.
9
FAN SPEED CONTROL BUTTON
Press this button to select the fan speed, HH, H, L of your choice.
10
TEMPERATURE SETTING BUTTON
Use this button for SETTING TEMPERATURE
(Operates with the front cover of the remote controller closed.)
11
PROGRAMMING TIMER BUTTON
Use this button for programming “START and/or STOP” time.
(Operates with the front cover of the remote controller opened.)
12
TIMER MODE START/STOP BUTTON
Refer to page 57.
13
TIMER RESERVE/CANCEL BUTTON
Refer to page 57.
14
AIR FLOW DIRECTION ADJUST BUTTON
Refer to page 56.
15
OPERATION MODE SELECTOR BUTTON
Press this button to select OPERATION MODE.
16
FILTER SIGN RESET BUTTON
Refer to the section of MAINTENANCE in the operation manual attached to the indoor unit.
17
INSPECTION/TEST OPERATION BUTTON
This button is used only by qualified service persons for maintenance purposes.
18
EMERGENCY OPERATION SWITCH
This switch is readily used if the remote controller does not work.
19
RECEIVER
This receives the signals from the remote controller.
20
OPERATING INDICATOR LAMP (Red)
This lamp stays lit while the air conditioner runs. It flashes when the unit is in trouble.
21
TIMER INDICATOR LAMP (Green)
This lamp stays lit while the timer is set.
22
AIR FILTER CLEANING TIME INDICATOR LAMP (Red)
Lights up when it is time to clean the air filter.
23
DEFROST LAMP (Orange)
Lights up when the defrosting operation has started.
(For cooling only type this lamp does not turn on.)
M H L
C
hr. hr.
TEST