Daikin OH08-1, Инструкция по эксплуатации

Страница: 136 / 150

Remote Controller (Wireless Type) OH08-1
134 Control Systems
Installing to a wall or a pillar
1. Fix the remote controller holder with the screws.
2. Slide the remote controller into the remote controller holder
from the top.
How to insert the batteries
1. Open the back cover of the remote controller by sliding it in the
direction of the arrow.
2. Insert the attached dry cell batteries. Properly insert, set the
batteries by matching the (+) and (–) polarity marks as indi-
cated. Then close the back cover as before.
3. RECEIVER INSTALLATION
(1) Preparations before installation
Remove the service lid and the front grill. See the installation manual that came with the main indoor unit
for details on removal.
(2) Determination of address and MAIN/SUB remote controller.
If setting multiple wireless remote controllers to operate in one room, perform address setting for the
receiver and the wireless remote controller.
If setting multiple wired remote controllers in one room, change the MAIN/SUB switch of the receiver.
SETTING PROCEDURE
1. Setting the receiver
Set the wireless address switch (SS2) on the transmission PC-board (2) according to the table below.
When using both a wired and a wireless remote
controller for 1 indoor unit, the wired controller
should be set to MAIN. Therefore, set the MAIN/SUB
switch (SS1) of the receiver to SUB.
(The wired remote controller will be “MAIN”.)
Unit No. No. 1 No. 2 No. 3
Wireless address
switch (SS2)
MAIN SUB
MAIN/SUB
switch (SS1)
1
2
Back cover
The side painted black indicates
the switch knob position.
1
2 3
M
S
SS2
SS1
Transmission
PC-board (2)
123 123 123
MS MS
C: 3P091240-1-3