11
Preparation before Operation
■
Installation of the unit
Installed on a table or the fl oor
100cm from ceiling
50cm from wall
50cm from wall
Airfl ow
10cm from wall
• The wall where the air purifi er is set may get dirty depending
on the type of wall and environment, even if you follow the
specifi ed dimensions of left. In such cases, move the unit a
safe distance away from the wall.
• If the air purifi er is used for a long time at the same location,
the bottom of the unit and fl oor may become dirty due to the
suction air fl ow from the bottom of the unit. Periodic cleaning is
recommended.
CAUTION
ATTENTION
• The air is blown slightly to the right, but nothing is wrong with the
unit.
• Select a location which allows the air to reach the entire room.
• Place the air purifi er on a fl at area where it is stable. If the fl oor is
uneven, the unit may vibrate excessively.
Hints for smart installation
• To remove house dust, it is effective to install the unit at a lower position in the room. To
remove cigarette smoke, it is effective to install the unit in a higher part of the room.
• If you install the air purifi er opposite the air conditioner, the circulation effect is enhanced.
The unit controls unevenness in the room temperature while cleaning the air during
heating or cooling operation.
• Keep TVs, radios and stereos 2m or more away from the unit.
(The effects of the power circuit inside the unit and cable may cause a distorted TV
picture or noise.)
Keep cordless phones or atomic radio clocks away from this unit also.
Airfl ow
Do not use the unit in the following places.
• Do not use the unit in a location exposed to direct sunlight.
(The response of the main unit to the signal from the remote controller may be weakened and the colour may change.)
• Do not use the unit in locations of high temperature.
(Heat may discolour and deform the unit.)
• Exposed to soot (conductive dust) generated by candles, aromatic candles, etc.
The operating effi ciency of the fi lter may be lowered, and the room may become dirty due to dust that is not collected.
• Near to a fi re alarm
If the air from the outlet is blown toward a fi re alarm, the alarm may respond late or it may not respond.
• Do not use cosmetics, etc. combined with silicone near the unit.
*Cosmetics, antiperspirant, antistatic agent, waterproof spray, spray polish, glass cleaner, chemical wiping cloths, wax, and hair care
products (split ends coating agent, hair mousse, and hair conditioner).
Insulators such as silicone may adhere to the needle of the streamer unit, and a streamer may not be generated. In this case, clean UNIT2.
►
Page 20.
01_EN_3P276413-4F.indd 11
8/1/2012 11:29:34 AM
