Daikin Madoka BRC1H82K, Инструкция по установке и эксплуатации

Страница: 56 / 136

13 | Operation
Installer and user reference guide
56
BK+S
Madoka wired remote controller
4P596268-1A – 2022.02
INFORMATION
When the system is stopped while the indoor unit is running in Heating operation
mode, the fan will continue to operate for approximately 1 minute, this to get out
any heat remaining in the indoor unit.
INFORMATION
▪
The lower the outdoor air temperature, the lower the heating capacity. If the
system's heating capacity is insufficient, it is recommended to include another
heating appliance into the setup (if you use a combustion appliance, ventilate the
room regularly. Also, do not use the heating appliance in places where it is
exposed to the airflow of the indoor unit).
▪
The indoor unit is of the hot air circulation type. As a result, after operation start,
it takes the indoor unit some time to warm up the room.
▪
The indoor unit fan will automatically operate until the indoor temperature of the
system rises to a certain level.
▪
When hot air stays under the ceiling and your feet feel cold, it is recommended to
include a circulator into the setup.
Dry
NOTICE
To prevent water leakage or system failure, do NOT turn off the system immediately
after indoor unit operation. Before turning off the system, wait until the drain pump
finishes discharging any water remaining in the indoor unit (approximately 1 minute).
INFORMATION
To ensure a smooth start, do not turn off the system while it is operating.
Auto
INFORMATION
In case of indoor unit setpoint logic, the system cannot run in Auto operation mode.
Therefore, to allow for Auto operation mode, go for remote controller setpoint logic.
For more information, see the Madoka Assistant app and
"Setpoint logic" [
4
108].
The Auto operation mode logic depends on the set setpoint logic (Madoka
Assistant app setting).
Single setpoint Dual setpoint
0.5°C ~ 2°C
0.5°C ~ 2°C
0.5°C ~ 2°C
0.5°C ~ 2°C
C2
+ C1
SP
+ C1
C2
0.5°C ~ 2°C
0.5°C ~ 2°C
0.5°C ~ 2°C
0.5°C ~ 2°C
DIFF
C2
+ C1
SP
+ C1
C2
SP
Cooling setpoint
Heating setpoint
DIFF Minimum setpoint differential between the Heating and the Cooling setpoint
+C1
Changeover setpoint (with guard timer)