Daikin Madoka BRC1H82K, Инструкция по установке и эксплуатации

Страница: 45 / 136

12 | Remote controller: Overview
Installer and user reference guide
45
BK+S
Madoka wired remote controller
4P596268-1A – 2022.02
12 Remote controller: Overview
In this chapter
12.1 About the controller ............................................................................................................................................................... 45
12.1.1 To configure the controller .................................................................................................................................... 46
12.2 Buttons.................................................................................................................................................................................... 46
12.3 Status icons ............................................................................................................................................................................. 47
12.4 Status indicator....................................................................................................................................................................... 48
12.4.1 Behaviour ............................................................................................................................................................... 48
12.1 About the controller
Depending on configuration, the controller is operable in either one of three
modes. Each mode offers different controller functionality.
Mode Functionality
Normal The controller is fully functional.
All functionality described under
"13 Operation" [
4
50] is available.
The controller can be a master or a
slave controller.
Alarm only The controller only acts as leak
detection alarm for a single indoor unit.
No functionality described under
"13 Operation" [
4
50] is available.
For information on the leak detection
alarm, see "7.2 Refrigerant leak
detection" [
4
33].
The controller can be a master or a
slave controller.
Supervisor The controller only acts as leak
detection alarm for the whole system,
i.e. multiple indoor units and their
respective controllers. This mode is
intended for a controller that is to be
used in a supervision location, e.g. the
reception desk of a hotel.
No functionality described under
"13 Operation" [
4
50] is available.
For information on the leak detection
alarm, see "7.2 Refrigerant leak
detection" [
4
33].
The controller can only be a slave
controller.
For more information on how to set the controller to be operable in a specific
mode, see
"12.1.1 To configure the controller" [
4
46]. When using “Supervisor”
mode, it is important to set the supervised room address in order to know for
which indoor unit the refrigerant leak alarm occurs. See
"Supervised room
address" [ 4 116] for more inormation.