Daikin Madoka BRC1H82K, Инструкция по установке и эксплуатации

Страница: 121 / 136

15 | About the app
Installer and user reference guide
121
BK+S
Madoka wired remote controller
4P596268-1A – 2022.02
INFORMATION
Also see the installation manual of the indoor unit and outdoor unit.
Precautions when performing a test operation
CAUTION
Before starting up the system, make sure:
▪
The indoor and outdoor unit wiring is completed.
▪
The switch box covers of the indoor and outdoor units are closed.
NOTICE
Turn ON the power 6 hours before operation in order to have power running to the
crankcase heater and to protect the compressor.
INFORMATION
After the installation of the refrigerant piping, drain piping, and electrical wiring,
make sure to clean the inside of the indoor unit, as well as the decoration panel.
To perform a test operation
1 Confirm that the indoor unit gas and liquid stop valves are open.
INFORMATION
It is possible that the pressure inside the refrigerant circuit does not rise, despite the
opened stop valve. This can be due to the expansion valve (or the like) blocking the
refrigerant, and does not obstruct the test run.
2 Open the Madoka Assistant app.
3 Navigate to the operation screen of the controller that is connected to the
indoor unit(s) on which you want to perform a test run.
4 In the operation screen, set the operation mode to Cooling.
5 Go to Unit settings by tapping the cogwheel in the upper right corner of the
operation screen.
Result: You are in the Unit settings menu.
6 Scroll down to the Maintenance section and tap Test operation.
Result: You are in the Test operation menu.
7 Tap Start test operation.
Result: The indoor unit(s) enter test operation mode, during which normal
operation is not possible.
8 Return to the operation screen.
9 Tap Vertical airflow direction.
10 Tap Fixed.
11 Cycle through the five fixed airflow directions, and confirm if the indoor unit
flaps behave correspondingly.
12 Return to the Test operation menu.
13 Tap Stop test operation.
Result: The indoor units leave test operation mode. Normal operation is
possible again.