11
Ŷ
English
Indoor Unit Installation
6.
Wiring
4GHGTCNUQVQVJGKPUVCNNCVKQPOCPWCNHQTVJGQWVFQQTWPKV
WARNING
r &QPQVWUGVCRRGFYKTGUGZVGPUKQPEQTFUQTUVCTDWTUVEQPPGEVKQPUCUVJG[OC[ECWUGQXGTJGCVKPIGNGEVTKEUJQEMQTƂTG
r
Do not use locally purchased electrical parts inside the product. (Do not branch the power for the drain pump, etc., from the
VGTOKPCNDNQEM&QKPIUQOC[ECWUGGNGEVTKEUJQEMQTƂTG
r &QPQVEQPPGEVVJGRQYGTYKTGVQVJGKPFQQTWPKV&QKPIUQOC[ECWUGGNGEVTKEUJQEMQTƂTG
CAUTION
r
When connecting the connection wire to the terminal block using a single core
wire, be sure to perform curling.
2TQDNGOUYKVJVJGKPUVCNNCVKQPOC[ECWUGJGCVCPFƂTGU
Good
Wrong
r
When clamping wiring, use the included clamping material to prevent outside pressure being exerted on the wiring
EQPPGEVKQPUCPFENCORƂTON[9JGPFQKPIVJGYKTKPIOCMGUWTGVJGYKTKPIKUPGCVCPFFQGUPQVECWUGVJGGNGEVTKECNYKTKPI
DQZEQXGTVQUVKEMWRVJGPENQUGVJGEQXGTƂTON[
r
Outside the unit, separate the low voltage wiring (remote controller wiring) and high voltage wiring (wiring between units,
ground, and other power wiring) at least 2 in. so that they do not pass through the same place together. Proximity may cause
electrical interference, malfunctions, and breakage.
6KIJVGPKPIVQTSWGHQTVJGVGTOKPCNDNQEMU
r
Use the correct screwdriver for tightening the terminal screws. If the blade of screwdriver is too small, the head of the
screw might be damaged, and the screw will not be properly tightened.
r
If the terminal screws are tightened too hard, screws might be damaged.
r
Refer to the table below for the tightening torque of the terminal screws.
WPKVNDHrHV0rO
Tightening torque
Terminal block for remote controller (6P)
0.58 - 0.72 (0.79 - 0.98)
Terminal block for power supply (4P)
0.87 - 1.06 (1.18 - 1.44)
Содержание FFQ09Q2VJU
Страница 62: ...21 ŶEspañol MEMO ...
Страница 63: ...22 ŶEspañol Español ...
Страница 64: ...Two dimensional bar code is a manufacturing code 3P436085 1 M15B215 1607 HT ...