Daikin EKHH2E200AAV3, Руководство по установке

Страница: 29 / 42

N
OTE
I
n case of “
UtL
” alarm (fault of the fan), in
addition to the display visualization, the
equipment emits an acoustic signal that can
be switched off pressing any key on the user
interface. The alarm is never cancelled
unless the equipment is switched off or put
in stand-by.
The heat pump working mode is automatically
disabled and the one with electric resistance
is activated in order to ensure the continuity
of the warm water supply.
PLEASE NOTE!
In
case of “UtL” alarm, you must contact the
technical assistance.
AL Minimum temperature alarm
Solution:
- Check the temperature associated with the
alarm;
-
Parameters
-
displayed: A0, A1, A2 and A11.
Main consequences:
-
The equipment will continue working regularly
AH Maximum temperature alarm
Solutions:
- Check the temperature associated with the
alarm;
-
Parameters displayed: A3, A4, A5 and A11.
Main consequences:
-
The equipment will continue working regularly.
id Digital input alarm
Solutions:
- Check the causes that initiated the input
activation (possible short circuit in signal
cables)
- See parameters: i0; i1 and i2;
Main consequences:
- Compressor will be switched off;
- Defrosting will not be activated.
iSd Blocked equipment alarm
Solutions:
-
Check the causes that initiated the digital input
activation
- See parameters: i0; i1; 18 and i9
-
Switch off the equipment and restart it, or
disconnect the equipment from the mains
power supply.
Main consequences:
-
Compressor will be switched off;
-
Defrosting will be never activated.
FiL Ventilation filter check alarm
Solutions:
-
Check how clean the filter is (to switch off the
alarm message, press any key on the display)
UtL Probable fan fault
Solutions:
- See parameters SP10 and C14
- Check the fan conditions
Main consequences:
-
Compressor and fan are switched off;
-
Water heating occurs, using only the electric
resistance.
When the error causing alarm has been
resolved, normal operation of the equipment
is restored.
8.1.3.12 Error messages
Pr1 Error in thermistor in upper part of the boiler
Solutions:
- Check whether the type of thermistor is in
conformity with parameter P0 settings;
- Check whether the thermistor is intact;
-
Check the equipment-thermistor connection;
-
Check the temperature of the upper part of
the boiler.
Main consequences:
- The equipment stops working.
Pr2
Error in thermistor in lower part of the boiler
Solutions:
- Identical to solution for error in thermistor in
upper part of the boiler (see above), but
applied to the lower part.
Main consequences:
-
The equipment stops working.
Pr3 Error in evaporator thermistor
Solutions:
- Identical to solution for error in thermistor in
upper part of the boiler (see above), but
applied to the evaporator thermistor.
- The equipment stops working.
When the error causing alarm has been
resolved, the normal operation of the
equipment is restored.