Daikin Climaa-Flex DWP Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 9 / 52

iom-cliwp-cf-eng www.clima-flex.com.mx
9
Figure 3. Removing filters.
Figure 4. Switching filter sizes.
Figure 2. Remove the air filter acces.
INSTALLATION
All ductwork, supplies and returns, must be properly sized to meet the equipment’s airflow design requirement. You refer to Air
Conditioning Contactors of America (ACCA), is an excellent guide to proper sizing.
Where ducts pass through unheated spaces, they should be insulated with a minimum of 1” of insulation. Flexible joints should be used
to connect ductwork to equipment to minimize noise transmission.
DUCTWORK
FILTER
The filters can be serviced from the outside by removing the Air
Filter access (See Figure 2).
Filter Installation / Removal
1. Remove the two screws located on each side of the filter
cover (See Figure 2).
2. Slide the filter tray outwards from the unit.
3. Carefully unbend the filter tabs that are pointing upwards
(See Figure 3).
4. Install the new filters and then reverse the sequence of steps
for the installation of the new filter.
NOTE: When installing new filters, make sure that airflow
arrows on filters point up.
Switching Filter Sizes
1. To switch from 1” to 2” filters, start by removing the filter
slide and bend the tabs down out of the way (See Figure
4).