Daikin BRC7E530W, Руководство по эксплуатации

Страница: 13 / 20

English 8
„
FAN OPERATION ...................... “ ”
„
DRY OPERATION ..................... “ ”
• See “FOR SYSTEMS WITHOUT COOL/
HEAT CHANGEOVER REMOTE CON-
TROL SWITCH” for details on dry operation.
(2) Press OPERATION MODE SELECTOR
button several times and select “ ”
(This operation is only available during
dry operation.)
ON/OFF
Press ON/OFF button
OPERATION lamp lights up or goes off and
the system starts or stops OPERATION.
NOTE
• Do not turn OFF power immediately after
the unit stops. Then, wait no less than
5 minutes.
Water is leaking or there is something else
wrong with the unit.
[EXPLANATION OF HEATING OPERA-
TION]
DEFROST OPERATION
• As the frost on the coil of an outdoor unit
increase, heating effect decreases and the
system goes into DEFROST OPERA-
TION.
• The fan operation stops and the
DEFROST lamp of the indoor unit goes on.
After 6 to 8 minutes (maximum 10 min-
utes) of DEFROST OPERATION, the sys-
tem returns to HEATING OPERATION.
Heating capacity & Outdoor air
temperature
• Heating capacity drops as outdoor air tem-
perature lowers. If feeling cold, use
another heater at the same time as this air
conditioner.
2
ON OFF
• Hot air is circulated to warm the room. It
will take some time from when the air con-
ditioner is first started until the entire room
becomes warm. The internal fan automat-
ically turns at low speed until the air condi-
tioner reaches a certain temperature on
the inside. In this situation, all you can do
is wait.
• If hot air accumulates on the ceiling and
feet are left feeling cold, it is recommended
to use a circulator. For details, contact the
place of purchase.
For programming TEMPERATURE, FAN
SPEED and AIR FLOW DIRECTION, follow
the procedure shown below.
TEMPERATURE SETTING
Press TEMPERATURE SETTING but-
ton and program the setting tempera-
ture.
Each time this button is pressed,
setting temperature rises 1
°
C.
Each time this button is pressed,
setting temperature lowers 1
°
C.
In case of automatic operation
Each time this button is pressed,
setting temperature shifts to “H”
side.
Each time this button is pressed,
setting temperature shifts to “L”
side.
[
°
C]
• The setting is impossible for fan operation.
NOTE
• The setting temperature range of the
remote controller is 16°C to 32°C.
ADJUSTMENT
DOWN
UP
DOWN
UP
DOWN
UP
H • M • L
Setting
temperature
25 23 22 21 19
01_EN_3P107422-1S.fm Page 8 Monday, June 2, 2008 5:55 PM