Daikin Altherma EHY2KOMB28AA, Руководство по установке для специалистов

Страница: 45 / 112

9 Installation
Installer reference guide
45
EJHA EHY32AA
Daikin Altherma Hybrid hydrosplit heat pump
4P531180-1 – 2018.06
a b
a Strip wire end to this point
b Excessive strip length may cause electrical shock or
leakage.
3 Insert the wiring at the back of the unit:
a
b
c
d
a~d See below
4 If you insert cables through the knockout holes c and d :
▪ Punch the knockout holes using a hammer and screw driver.
▪ Insert the cable glands (delivered as accessory).
5 Inside the unit, route the wiring to the switch box as follows:
3×
a
b
c
d
a~d See below
6 Inside the switch box, connect the wires to the appropriate
terminals.
7 After connecting all wiring, close the front plate and the top
plate.
Connections in case of third-party gas boiler
Routing Possible cables (depends on the installed
options)
a
Main power supply
(high voltage)
Main power supply
Routing Possible cables (depends on the installed
options)
b
User interface (low
voltage)
User interface (mandatory option)
c
High voltage
▪ Bivalent signal for third-party gas boiler
(field supply)
▪ External pump cable – Power supply
(mandatory option)
d
Low voltage
▪ External outdoor temperature sensor
(option)
▪ LAN adapter (option)
▪ External pump cable – PWM signal
(mandatory option)
INFORMATION
Bottom plate heater (option) . For the routing, see the
installation manual of the bottom plate heater.
To connect the main power supply
1 Connect the main power supply to the appropriate terminals as
shown in the illustration below.
1N~ 50 Hz
220-240 V
PE N L
Q1DI 1 2 3
L N
X2M
1×
a
3×
a Recommended field fuse: 20 A
Q1DI Earth leakage circuit breaker
2 Fix the cable with cable ties to the cable tie mountings.