Instruction
SiBE12-933_A
156
Operation Manual
outdoor drain pipes during air-conditioning
operation, chances are that dust and dirt are
clogged in the pipe. This may result in a water
leakage from the indoor unit. Under such
circumstances, stop the operation of the air
conditioner, and then con sult your dealer or our
service station.
11
DISPLAY “
” (TIME TO CLEAN AIR
FILTER)
Refer to “HOW TO CLEAN THE AIR FILTER”.
12
DISPLAY “
” (DEFROST)
Refer to “DEFROST OPERATION”.
13
NON-FUNCTIONING DISPLAY
If that particular function is not available,
pressing the button may display the words
“NOT AVAILABLE” for a few seconds.
When running multiple units simultaneously
The “NOT AVAILABLE” message will only be
appear if none of the indoor units is equipped
with the function. If even one unit is equipped
with the function, the display will not appear.
Refer to figure 1 on page [1]
14
TIMER MODE START/STOP BUTTON
1
ON/OFF BUTTON
Refer to “PROGRAM TIMER OPERATION”.
Press the button and the system will start.
Press the button again and the system will
stop.
15
TIMER ON/ OFF BUTTON
Refer to “PROGRAM TIMER OPERATION”
16
INSPECTION/TEST OPERATION BUTTON
2
OPERATION LAMP (RED)
This button is used only by qualified service
persons for maintenance purposes.
The lamp lights up during operation.
3
DISPLAY “
” (UNDER
CENTRALIZED CONTROL)
17
PROGRAMMING TIME BUTTON
Use this button for programming “START
and/or STOP” time.
When this display shows, the system is
UNDER CENTRALIZED CONTROL.
18
TEMPERATURE SETTING BUTTON
4
DISPLAY “
” “
” “
” “
”
(VENTILATION/AIR CLEANING)
Use this button for SETTING
TEMPERATURE.
This display shows that the total heat
exchange and the air cleaning unit are in
operation (These are optional accessories).
19
FILTER SIGN RESET BUTTON
Refer to “HOW TO CLEAN THE AIR FILTER”.
20
FAN SPEED CONTROL BUTTON
5
DISPLAY “
” “
” “
” “
” “
”
(OPERATION MODE)
Press this button to select the fan speed,
HIGH or LOW, of your choice.
This display shows the current OPERATION
MODE. For cooling only type, “
” (Auto)
and “
” (Heating) are not installed.
21
OPERATION MODE SELECTOR BUTTON
Press this button to select OPERATION MODE.
22
AIR FLOW DIRECTION ADJUST BUTTON
6
DISPLAY “
TEST
” (INSPECTION/TEST
OPERATION)
Refer to “AIR FLOW DIRECTION ADJUST”.
NOTE
• For the sake of explanation, all indications are
shown on the display in figure 1 contrary to
actual running situations.
When the INSPECTION/TEST OPERATION
BUTTON is pressed, the display shows the
system mode is in.
7
DISPLAY “
” (PROGRAMMED TIME)
This display shows the PROGRAMMED
TIME of the system start or stop.
8
DISPLAY “
” (SET TEMPERATURE)
This display shows the set temperature.
Refer to figure 1 on page [1]
• Operating procedure varies with heat pump type
and cooling only type. Contact your Daikin dealer
to confirm your system type.
• To protect the unit, turn on the main power switch
6 hours before operation.
9
DISPLAY “
” (FAN SPEED)
This display shows the set fan speed.
10
DISPLAY “
” (AIR FLOW FLAP)
Refer to “AIR FLOW DIRECTION ADJUST”.
5. NAME AND FUNCTION OF EACH
SWITCH AND DISPLAY ON THE
REMOTE CONTROLLER
6. OPERATION PROCEDURE