Daihen OTC Welbee WB-M350, Руководство пользователя

Страница: 92 / 144

S
ETTING
I
NTERNAL
F
UNCTIONS
W
ELDING
C
ONDITION
C
HAPTER
6
6-30
6.7.2.11 F14/F15: Start control (time/current) adjustment
Set the time and current for start control to be performed at the time of welding start.
Depending on the welding conditions and set current value, the appropriate time and current for start
control are determined; if proper burning of the wire does not occur at the time of start, adjust the time
and current for start control.
For more intense burning, increase the time and current.
For less intense burning, reduce the time and current.
• Set the time from -50 to 50 % through F14 (Start control time adjustment).
• Set the current in the range from -100 to 100 A through F15 (Start control current adjustment).
6.7.2.12 F16: Slowdown speed adjustment
Slow-down speed is the speed to slowly feed the wire from the time of the machine start to the time of
arc start.
The slowdown speed is automatically set to an appropriate speed depending on the welding method and
wire diameter; meanwhile, it can be adjusted through this function if manual setting is preferred.
The setting range is ±39 IPM (±1.0 m/min), yet cannot be adjusted slower than 16 IPM (0.4 m/min).
Based on "0," adjusting it to the negative direction lowers the speed, and adjusting it to the positive
direction accelerates the speed.
When the starting performance is poor, decrease the slow-down speed to a negative value (which lowers
the wire feed speed).
When the starting performance is not poor, setting the slow-down speed to a positive value (which
accelerates the wire feed speed) can shorten the tact time.
Time
Current
Turbo start current
Start current