M
EMORY
F
UNCTION
OF
W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
6-12
2.
Turn the parameter adjustment knob, and select the JOB No. to read out.
3.
Press the ENTER key.
4.
Press the ENTER key.
⇒
The welding condition is registered with the selected JOB No., and the read mode is terminated.
The selected position on the operation panel and the current/voltage values are overwritten to those
read out.
6.5.3
Deletion of memory registration
This section explains how to delete the welding conditions registered to the memory.
NOTE
• The deleted data cannot be restored. Before deleting the stored welding condition, carefully
check the welding JOB No. to delete.
⇒
When there is no registration data on the selected
JOB No., "- - -" is displayed on the left digital meter.
⇒
When there is any registration data on the selected
JOB No., the setting value of the welding current is
displayed on the left digital meter. At this time, the
LEDs for the keys of crater or wire material also light
up.
⇒
The LED of ENTER key flashes.
⇒
Pressing the DISPLAY CHANGE key enables to
check the set values of welding conditions (welding
parameters) to read out. The setting values are
displayed on the left/right digital meters in a
flashing mode.
⇒
To change the JOB No. to read out, press the LOAD
key. The display returns to the status described in
step 1.
⇒
To cancel the read out, press the SAVE key. The read
mode is terminated.
A
V
r
㧑
WARNING
IPM.
sec.
JOB No.
Hz
ENTER
㧔
3 sec.
㧕
ENTER
㧔
3 sec.
㧕
Содержание OTC Welbee WB-M350
