24
Parameter
Function
Host name
Set current host name. Max supports 15 characters.
Ethernet card
Set Ethernet card to config. Default is wired.
Mode
You can select from static and DHCP mode. In DHCP mode, it automatically
searches IP while you cannot set IP/subnet mask/gateway. Plus IP/subnet
mask/gateway display values from DHCP. In static mode, you shall manually set
IP/subnet mask/gateway. To switch from DHCP to static, you must set IP
parameters again.
MAC address
Display host MAC address.
IP version
Select IP version IPV4 or IPV6. These two IP addresses both can be accessed.
IP address
Input new IP address to edit, and set subnet mask and default gateway.
Preferred DNS
DNS server IP address.
Alternate DNS
DNS server alternate IP address.
Step 3. Click Save.
5.5.3.2 Connection
If you want to access the device via different protocols or config tool, please set connection port.
Step 1. Select Network>Connection. See Figure 5- 18.
Figure 5- 17
Step 2. Refer to the following chart.
Parameter
Note
Max Connection
One device allows up to this number of connections of WEB login,
default is 20.
TCP Port
TCP protocol provides server port, default is 37777
UDP Port
User data protocol port, default is 37778
HTTP Port
HTTP communication port, default is 80
RTSP Port
Default is 554
Step 3. Click Save.
5.5.3.3 IP Filter
By setting the allowlists and blocklists, you can enable or disable some users log in to the device.
Step 1. Select Network>IP Filter.
Step 2. Select Allowlist or Blocklist.
