22
Figure 5- 13
Step 1. Select Analog Camera>Video. See Figure 5- 15.
Figure 5- 14
Step 2. Refer to the following chart. Click Save.
Parameter
Note
Analog Channel
Select corresponding analog channel.
Stream Type
May select general.
Encode Mode
May select H.264M, H.264B or H.264H
Resolution
Front-end device encode setup, support D1
（
704*576
）
, HD1
（
352*576
）
, CIF
（
352*288
）
Frame Rate
PAL
：
1 fps~25 fps
Bit Rate Type
CBR and VBR.
Bit Rate
Set bi rate to change image quality. The bigger the bit rate, the
better the quality.
I Frame Interval
PAL frames between to frames, range change following frame
rate. Max is 150, 2x is recommended.
Watermark Settings
Checked, system will add watermark, default characters are
：
DigitalCCTV.
Step 3. Click Overlay, select analog channel, configure channel and time.
Check the "channel title", click Config, drag the red box to adjust the position title, enter a
channel title.
Check the "Time Title" and click Config, drag the red box to adjust the time location, check
the "day of the week."
